Table of Contents
Advertisement
Operation
1. Restore electrical power by turning on the electricity at the main fuse box.
2. Turn on the wall switch
3. Your fan has 2 controls on the switch housing.
Speed Control
Pull Chain Switch
(pull gently)
Pull Speed
1
High
2
Medium
3
Low
4
Off
Remote Control
Battery
remove the small Phillips head screw that
Door
secures the battery door to the transmitter
Phillips
Head
Screw
To access the battery compartment,
assembly. The battery should be installed
with the positive (+) side up. Replace
with a CR2032 battery when necessary.
The remote transmitter should already be paired
to the receiver and ready to use.
Note: If your need to pair your remote, turn
fan power off and back on at the wall switch.
Within 3 minutes, press and hold both the
Fan OFF button and the Fan ON button for
4 seconds to pair the remote. To prevent
faulty operation, please ensure all other
ceiling fans within range are turned off
at the wall switch while pairing.
ME008-01
10
11/11/2014
Advertisement
Table of Contents
