Select Type Of Installation; Hang Down Style - Revolutions Solaris Owner's Manual

Select Type of Installation

Hang Down
This method is preferred if the ceiling is
sloped, vaulted, or if the ceiling is extra high
and requires the use of a downrod.
,8 Meters
from blade tip
to nearest wall
or obstruction

Hang Down Style

1.Slide the canopy onto the downrod (Fig. 2). Thread the power leads from the fan through the
canopy and downrod. Take care not to pull excessively on power wires. Damage and loose
connections could result from any abnormal pressure on these wires. Set the downrod into the yoke.
Rotate until the holes match. Be careful not to damage the wiring. Insert connector pin through the
holes (Fig. 2A and 2B). Secure the pin by inserting the stop pin through the connector pin.
Fig. 2
Ball
WARNING: Do not force the connector pin through the downrod. Use of force could cause damage
to the wires inside. Make sure the stop pin is properly engaged to prevent it from falling out. Failure to
properly install locking pin as noted could result in fan loosening and possible falling.
CAUTION
To reduce the risk of injury to
persons, install fan so that the blade
2,1 Meters
is at least 2,1 m above the floor.
from bottom
edge of blade to
the floor
Fig. 2A
Power Lead
Downrod
Fig. 2B
Canopy
6
ME008-01 11/11/2014
Hugger
This method is preferred if maximum
headroom is required. The celing must not
be flat and not sloped.
Downrod
Mounting Collar Yoke
Canopy
Stop Pin
Canopy
Connector
Pin