Assembly Instructions 3001Kl-Am/3001Kl-Amc Scale - Health O Meter 3001KL-AM User Instructions

Antimicrobial digital platform scale
Hide thumbs Also See for 3001KL-AM:
Table of Contents

Advertisement

3001KL-AM/3001KL-AMC ASSEMBLY INSTRUCTIONS
Before Installation
Each 3001KL-AM/3001KL-AMC Antimicrobial scale is shipped for immediate use inside
a single carton. Carefully inspect the outside carton for shipping damage before
unpacking. If damage is found, contact your shipper or a Health o meter
representative immediately at 1-800-815-6615. Claims must be filed with the shipper as
soon as possible after receipt of the package.
The following information will detail what you will find inside the main carton as you
unpack. To prevent damage to the scale, carefully remove the unit from the carton and
remove all packing materials. Set the carton aside for storage. To avoid scratching any
of the scale parts when unpacking, do not use a box cutter, knife, scissors, or any sharp
object to open the protective packaging.
Parts List
• 3001KL-AM/3001KL-AMC Scale, Fully Assembled
• Directions for Use (located in enclosed envelope)
• Quick Reference Guide (located in enclosed envelope)
• (6) AA Batteries
Tools Required
Phillips head screwdriver (not included) to install batteries.
Setting up the 3001KL-AM/3001KL-AMC Scale (Refer to Figures 1-2)
Caution: It is recommended that the scale setup be performed by two persons.
Warning: Do not drop scale, as this can permanently damage the load cells.
1. Remove the fully assembled scale by carefully lifting it out from the carton and place
scale platform on a flat, level, and dry surface.
2. Carefully remove the batteries, wrapped inside bubble wrap. The batteries are
attached to the upper handrail.
3. Remove the protective plastic film covering the display (the film is printed "FACTORY
CALIBRATED").
4. Place batteries into the battery holder, located on the side of the display assembly
(see "Replacing / Inserting Batteries" information below).
5. For the 3001KL-AM model only, connect the AC adapter into the adapter jack (the
jack is located on the rear of the display assembly). Plug the scale's AC adapter into
the power source.
Note: Use of AC adapter not available on 3001KL-AMC model.
6
®
Professional

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3001kl-amc

Table of Contents