Specifications - Makita HM1802 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch lever
2-1. Power-ON indicator lamp (green)
2-2. Service indicator lamp (red)
3-1. Soft grip
3-2. Bolt

SPECIFICATIONS

Blows per minute
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for heavy chiselling and demolition work as
well as for driving and compacting with appropriate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted
according to EN60745:
Model HM1802
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Model HM1812
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Model HM1802
Work mode : chiselling
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
4-1. Triangle alignment mark
5-1. Bit with collar
5-2. Bit without collar
6-1. Bit
6-2. Tool retainer
Model
Dimensions
Net weight
Safety class
noise level determined
) : 95 dB (A)
pA
) : 106 dB (A)
WA
) : 96 dB (A)
pA
) : 107 dB (A)
WA
value (tri-axial vector
2
) : 14.0 m/s
h,CHeq
2
HM1802
29.4 kg
ENE046-1
Model HM1812
Work mode : chiselling
Vibration emission (a
ENF002-2
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
ENG905-1
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the power
•
tool can differ from the declared emission value
depending on the ways in which the tool is used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
ENG900-1
Designation of Machine: Electric Breaker
sum)
Model No./ Type: HM1802,HM1812
Specifications: see "SPECIFICATIONS" table.
Conforms to the following European Directives:
2000/14/EC, 2006/42/EC
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
3
6-3. Tool holder
7-1. Notched portion of the bit
7-2. Tool retainer
7-3. Tool holder
HM1812
870
843 x 210 x 608 mm
31.3 kg
/II
) : 6.5 m/s
h,CHeq
2
2
ENG901-1
ENH213-9