Light Bulbs; Maintenance; Operation - Broan B5830SS Instructions Manual

LIGHT BULBS

!
!
WARNING
VQ0010
Bulbs may be hot. Always allow bulbs to cool down before
removing them.
This range hood requires two halogen bulbs (Type JC, 12V, 20W
Max, G-4 Base).
To change bulbs:
!
VQ0010
1. Remove light bulb cover by gently pushing it upward and
turning it counterclockwise.
2. Replace bulb.
3. Re-install light bulb cover by gently pushing it upward and
turning it clockwise.

OPERATION

OFF LOW
FAN CONTROLS
The hood is operated using the push buttons on the front panel.
Push the light button to turn the lights on and off.
Push the fan controls to select low, medium, or high blower
speed.
Push the OFF button to turn the blower off.
LIGHT BULB COVER
MED.
LIGHT
HIGH
ON/OFF
MODELS B5830SS • B5836SS

MAINTENANCE

Grease Filters
Grease filters should be cleaned monthly. Remove grease
filters by pulling down on the metal latch tab. This will
disengage the filter from the hood. Tilt the filter downward and
remove.
To clean all-metal filters: Use a warm detergent solution or
put them in the dishwasher using a non-phosphate detergent.
Discoloration of the filter may occur if using phosphate
detergent or as a result of local water conditions - but this will
not affect filter performance. This discoloration is not covered
by the warranty.
Non-Duct Recirculation Filters
Change the non-duct recirculation filters every 6 months.
Rotate the filters to remove them from the blower and replace.
Hood Cleaning
How to maintain the bright look of stainless steel and help
prevent corrosion.
Dos:
- Once a month, wash surfaces with clean cloth or rag soaked
with warm water and mild soap or liquid dish detergent.
- Always clean in the direction of original polish lines.
- Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe dry completely.
- You may also use a specialized household stainless steel
cleaner.
Don'ts:
- Do not use any steel or stainless steel wool or any other
scrapers to remove stubborn dirt.
- Do not use any harsh or abrasive cleansers.
- Do not allow dirt to accumulate.
- Do not let plaster dust or any other construction residues
reach the hood. During construction or renovation, cover the
hood to make sure no dust sticks to stainless steel surface.
Avoid: when choosing a detergent
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing : chloride, fluoride, iodide,
bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as
acetone, alcohol, ether, benzol, etc., are highly explosive
and should never be used close to a range.
Page 8