Table of Contents
Advertisement
16. INSTALL THE BLOWER
Refer to instructions included with blower.
Plug the 3-prong plug cord from rough-in plate to the 3-prong male connector inside the
hood (A) and the 2-prong male connector cord from rough-in plate to the 2-prong plug inside
the hood (B).
Do not plug the 2 cords together.
17. REINSTALL GREASE DRIP RAIL AND BAFFLE FILTERS
Reinstall grease drip rail. The illustration at right shows how to reinsert the grease drip rail
into the range hood.
Remove protective plastic film covering filters before installing them.
It is recommended to install side filters first and finish
with center one(s).
1.
Insert one end of the filter into the upper channel
of the hood.
2.
Raise the other end toward the inside of hood
and insert in the grease drip rail of the hood.
18. INSTALL LIGHT BULBS
This hood requires 50 W max., 120 V with GU10 base, shielded halogen bulbs (not included). (2 required for 30" and 36" hood widths or
3 for 42" and 48" hood widths.)
Do not touch lamps during or soon after operation. Burns
may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a cool
beam, a dichroïc lamp, a lamp not suitable for use in recessed
luminaires or identified for use in enclosed fixtures.
1. Install bulbs by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
To remove bulbs, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: If need be, use a rubber dishwashing glove to add grip when removing the bulb.
(EXTERIOR OR IN-LINE BLOWER)
WARNING
!
WARNING
!
CAUTION
1
HD0245
12
B
HE0078
HD0244
2
1
HO0090
A
2
Advertisement
Table of Contents
