Install The Ductwork; Prepare The Hood; Measure The Installation - Broan B5830SS Instructions Manual

INSTALL THE DUCTWORK

(Ducted Hoods Only)
1. Decide where
the ductwork
will run
between the
hood and the
outside.
2. A straight, short
duct run will
allow the hood
to perform most
efficiently.
3. L ong duct
runs, elbows
and transitions
ABOVE COOKING SURFACE
will reduce the
performance of
the hood. Use as few of them as possible. Larger ducting
may be required for best performance with longer duct runs.
4. I nstall wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.

MEASURE THE INSTALLATION

6" ROUND DUCT
DECORATIVE FLUE
ROUND ELBOW
HOOD
11 3/4"
30" TO 36" ABOVE
COOKING SURFACE
The minimum hood distance above cooktop MUST NOT BE
LESS than 30".
A maximum of 36" above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 36" are at the installer and users discretion;
providing that the ceiling height permits.
ROOF CAP
6"
ROUND DUCT
DECORATIVE
WALL CAP
FLUE
HOOD
ROUND
ELBOW
30" TO 36"
ROOF CAP
WALL CAP
HOOD
MOUNTING
BRACKET
12 5/8"
TO CENTER OF
BRACKET HOLES
MODELS B5830SS • B5836SS

PREPARE THE HOOD

Unpack hood and check contents. You should receive:
1 - Hood
1 - Decorative Flue Assembly
1 - Damper / Duct Connector
1 - Lower Flue Mounting Bracket
1 - Upper Flue Mounting Bracket
1 - Hood Mounting Bracket
2 - Aluminum Grease Filters (installed in hood)
1 - Parts Bag containing:
10 - Mounting Screws (#8 x 3/8" Pan Head)
7 - Mounting Screws (#8 x 1-1/2" Flat Head)
7 - Drywall Anchors
2 - Washers
1 - Installation Manual
7 MOUNTING
SCREWS
(#8 X 1-1/2"
Flat Head)
DECORATIVE FLUE
FLUE MOUNTING
BRACKET
DAMPER / DUCT
FLUE MOUNTING
CONNECTOR
10 MOUNTING
SCREWS (#8 x
3/8" Pan Head)
2 WASHERS
UPPER
7 DRYWALL
ANCHORS
LOWER
BRACKET
HOOD
MOUNTING
BRACKET
Page 2