Charcoal Embers; Logo Placement - Napoleon BGD40-N Installation And Operating Instructions Manual

38
When pieces #3a and #3b are attached
E.
to create log #3, the upper end of log #3
should rest in the groove, on top of log # 2.
The slot in the underside of piece #3b fi ts
over #3a. Place the end of piece #3b onto
the pin.
Like log #3, log #5 also comes in two
G.
pieces. The base (#5a) slopes outwards
between logs #2 and #4.
As with pieces #3a & b, piece #5b fi ts over
piece #5a. Place the end of piece #5b onto
the pin.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
Positioning the logs improperly will cause fl ame impingement and carboning.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. Phazer
logs glow when exposed to direct fl ame. Use only certifi ed Phazer
dealer / distributor.
9.6

CHARCOAL EMBERS

Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner.
Fine dust found in the bottom of the bag should not be used.
NOTE: Charcoal embers are not to be placed on the burner.
9.7

LOGO PLACEMENT

Remove the backing of the logo supplied and place on the glass viewing door,
as indicated.
W415-0811 / D / 08.16.12
As with log # 1, log #4 is also cradled by the
F.
texture of the burner and the pin in the
base. Position log #4 so that the lower end
fi ts onto the pin. The upper end rests against
the moulded locator on the top of log # 1.
The upper end of log #5 rests in the groove,
H.
on top of log #4 and creates the fi nal ap-
pearance of the log set.
logs available from your authorized
TM
TM
32.1
½"
LOGO
½"
97.1