General Information; Rating Plate Information - Napoleon BGD40-N Installation And Operating Instructions Manual

2.3

GENERAL INFORMATION

FOR YOUR SATISFACTION, THIS APPLIANCE HAS BEEN TEST-FIRED TO ASSURE ITS OPERATION AND
QUALITY!
Altitude (FT)
Max. Input (BTU/HR)
Max. Output Steady State (BTU/HR)
Min. Inlet Gas Supply Pressure
Max. Inlet Gas Supply Pressure
Manifold Pressure (Under Flow Conditions)
When the appliance is installed at elevations above 4,500 ft, and in the
absence of specifi c recommendations from the local authority having
jurisdiction, the certifi ed high altitude input rating shall be reduced at the
rate of 4% for each additional 1,000 ft.
This appliance is approved for bathroom, bedroom and bed-sitting room
installations and is suitable for mobile home installation.
No external electricity (110 volts or 24 volts) is required for the gas system
operation. Expansion / contraction noises during heating up and cooling
down cycles are normal and are to be expected.
If utilizing one of Wolf Steel's trim or surround kits, follow the framing instructions and the fi nishing instructions,
for removal of the top extension.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room temperature
but this can be improved if the assembly is warmed, using a hair dryer or similar heat source.
2.4

RATING PLATE INFORMATION

DIRECT VENT GAS FIREPLACE. APPROVED FOR BEDROOM, BATHROOM AND BED-SITTING
ROOM INSTALLATION. SUITABLE FOR MOBILE HOME INSTALLATION IF INSTALLED IN
ACCORDANCE WITH THE CURRENT STANDARD CAN/CSA Z240MH SERIES GAS
EQUIPPED MOBILE HOMES, IN CANADA OR IN THE UNITED STATES THE
MANUFACTURED HOME CONSTRUCTION AND SAFETY STANDARD, TITLE 24 CFR,
PART 3280. WHEN THIS US STANDARD IS NOT APPLICABLE USE THE STANDARD FOR
FIRE SAFETY CRITERIA FOR MANUFACTURED HOME INSTALLATIONS, SITES AND
COMMUNITIES, ANSI / NFPA501A.
NOT FOR USE WITH SOLID FUEL. FOR USE WITH
COVERS AND GLASS DOOR CERTIFIED WITH THIS
UNIT ONLY.
WARNING:
CONTACT WITH THE FLAMES, OTHER THAN THAT SUPPLIED BY THE MANUFACTURER WITH
THE APPLIANCE.
MINIMUM CLEARANCE TO COMBUSTIBLE MATERIALS /
DEGAGEMENTS MINIMAUX DES MATERIAUX COMBUSTIBLES:
TOP, FLOOR, SIDES & BACK
DESSUS, PLANCHER, COTES ET ARRIERE
RECESSED DEPTH (CORNER INSTALLATION ONLY)
PROFONDEUR D'ENCASTRE (INSTALLATION DU COIN SEULEMENT)
VENT / EVENT
MANTEL HEIGHT / HAUTEUR DU MANTEAU
MAXIMUM HORIZONTAL EXTENSION/L'EXTENSION HORIZONTALE MAXIMALE: 3". SEE
INSTRUCTION MANUAL FOR GREATER EXTENSIONS. REFERER AU MANUEL
D'INSTRUCTION POUR DES EXTENSIONS PLUS GRANDES.
MINIMUM AND MAXIMUM HORIZONTAL VENT LENGTHS ARE 10 INCHES AND 20 FEET
RESPECTIVELY. LES LONGUEURS HORIZONTALES MINIMALE ET MAXIMALE SONT 10
POUCES ET 20 PIEDS RESPECTIVEMENT.
WOLF STEEL LTD.
24 NAPOLEON ROAD, BARRIE, ON, L4M 0G8 CANADA
For rating plate location, see "INSTALLATION OVERVIEW" section.
This illustration is for reference only. Refer to the rating plate on the appliance for accurate information.
NOTE: The rating plate must remain with the appliance at all times. It must not be removed.
CERTIFIED UNDER / HOMOLOGUE SELON LES NORMES: ANSI Z21.50b-2009 CSA 2.22b-2009 VENTED GAS FIREPLACE / FOYER AU GAZ AVEC EVACUATION
BGD40G- N BGD40-N BCDV400-N
0-4500FT (0-1370m) ALTITUDE / ELEVATION
30,000 BTU/h INPUT / ALIMENTATION
20,000 BTU/h REDUCED INPUT / ALIMENTATION REDUITE
MANIFOLD PRESSURE: 3.5" WATER COLUMN
PRESSION AU COLLECTEUR: 3.5" D'UNE COLONNE D'EAU
MINIMUM SUPPLY PRESSURE: 4.5" WATER COLUMN
PRESSION D'ALIMENTATION MINIMALE: 4.5" D'UNE COLONNE D'EAU
MAXIMUM SUPPLY PRESSURE: 7.0" WATER COLUMN
PRESSION D'ALIMENTATION MAXIMALE: 7.0" D'UNE COLONNE D'EAU
DO NOT ADD ANY MATERIAL TO THE APPLIANCE, WHICH WILL COME IN PPLIANCE, WHICH WILL COME IN
PPLIED BY THE MANUFACTURER WITH PLIED BY THE MANUFACTURER WITH
ALS / ALS /
OMBUSTIBLES: USTIBLES:
ATION ONLY)
LATION DU COIN SEULEMENT) LATION DU COIN SEULEMENT)
MANTEAU MANTEAU
NSION/L'EXTENSION HORIZONTALE M SION/L'EXTENSION HORIZONTALE M
R GREATER EXTENSIONS. REFERER A REATER EXTENSIONS. REFERER
EXTENSIONS PLUS GRANDES. TENSIONS PLUS GRANDES
IZONTAL VENT LENGTHS ARE ZONTAL VENT LENGTHS AR
RS HORIZONTALES MINIM S HORIZONTALES MINIM
EMENT. .
8 CANAD CANA
NG
0-4,500
30,000
20,400
4.5" Water Column
7" Water Column
3.5" Water Column
G
FOYER A GAZ VENTILE DIRECT. HOMOLOGUE POUR INSTALLATION DANS UNE CHAMBRE A
COUCHER, USE SALLE DE BAIN ET UN STUDIO. APPROPRIE POUR INSTALLATION
DANS UNE MAISON MOBILE SI SON INSTALLATION CONFROME AUX EXIGENCES DE LA
NORME CAN/CSA Z240MH SERIE DE MAISONS MOBILES EQUIPEES AU GAZ, EN SA Z240MH SERIE DE MAI
VIGUEUR AU CANADA OU AUX ETATS-UNIS DE LA NORME DE SECURITE ET DE CANADA OU AUX ETATS-UNIS CANADA OU AUX ETATS-UNIS
CONSTRUCTION DE MAISONS MANUFACTUREES, TITRE 24 CFR, SECTION 3280. CTION DE MAISONS MANUFACTURE
DANS LE CAS OU CETTE NORME D'ETATS-UNIS NE PEUT ETRE APPLIQUEE, SE E CAS OU CETTE NORME D'ETATS-U
REFERER A LA NORME RELATIVE AU CRITERE DE MESURES DE SECURITE CONTRE RER A LA NORME RELATIVE AU CRITER
L'INCENDIE POUR LES INSTALLATION DANS LES MAISONS MANUFACTURES, LES CENDIE POUR LES INSTALLATION D CENDIE POUR LES INSTALLATION DA
9700539 (WSL) 4001657 (NGZ) 4001657 (NGZ) 40016
4001658 (NAC) 4001659 4001659 (WUSA) 4001659 (WUSA)
MODEL EL L BGD40-P BGD40-P BGD40-P
0-4500FT (0-1370m) (0-1370m) (0-1370m)
30,000 BTU/h 000 BTU/h 00 BTU/h
20,000 BTU/h 0,000 BTU/h 0,000 BTU/h
LUMN UMN MANIFOLD PRESSURE: MANIFOLD PRESSURE: 10" WATER COLUMN NIFOLD PRESSURE: 10"
E D'EAU D'EAU PRESSION AU COLLECTEUR: 10" D'UNE COLONNE D'EAU PRESSION AU COLLECT PRESSION
R COLUMN COLUMN MINIMUM SUPPLY PRE MINIMUM SUPPLY PRESSURE: 11" WATER COLUMN MINIMUM
ONNE D'EAU ONNE D PRESSION D'ALIMENTATION MINIMALE: 11" D'UNE COLONNE D'EAU PRESSION D'ALIME PRESS
WATER COLUMN ATER COLUM MAXIMUM MAXIMUM SUPPL MAXIMUM SUPPLY PRESSURE: 13" WATER COLUMN
COLONNE D'EAU COLONNE D'EAU PRESSION D PRESSION D'A PRESSION D'ALIMENTATION MAXIMALE: 13" D'UNE COLONNE D'EAU
UN CO UN COMBUSTIBLE SOLIDE NE DOIT PAS ETRE UTILISE N CO
SE WITH E WITH
AVE AVEC CET APPAREIL. UTILISER AVEC LES AV
WITH THIS WITH THIS
COUVERTURES ET LES PORTES VITREES C CO
HOMOLOGUEES SEULEMENT AVEC CETTE UNITE.
HICH WILL COME IN
AVERTISSEMENT:
ENTRER EN CONTACT AVEC LES FLAMMES AUTRE QUE CELUI QUI EST FOURNI AVEC CET
APPAREIL PAR LE FABRICANT.
THE APPLIANCE MUST BE VENTED USING THE APPROPRIATE WOLF STEEL VENT KITS. SEE
0"
OWNERS INSTALLATION MANUAL FOR VENTING SPECIFICS. PROPER REINSTALLATION AND
RESEALING IS NECESSARY AFTER SERVICING THE VENT-AIR INTAKE SYSTEM.
25 1/4"
L'APPAREIL DOIT EVACUER SES GAZ EN UTILISANT L'ENSEMBLE D'EVACUATION PROPRE A
1"
WOLF STEEL. REFERER AU MANUEL D'INSTALLATION DE PROPRIETAIRE POUR
5"*
L'EVACUATION PRECISE. IL EST IMPORTANT DE BIEN REINSTALLER L'EVENT APRES AVOIR
ASSURE LE MAINTIEN DU SYSTME DE PRISE D'AIR.
ELECTRICAL RATING / CLASSIFICATION: 115V, 0.82 AMP, 60HZ
OPTIONAL FAN KIT / ENSEMBLE DE VENTILATEUR FACULTATIF: GZ-550KT
SERIAL NUMBER/
NO. DE SERIE:
0-4500
30,000
20,400
11" Water Column
13" Water Column
10" Water Column
66.8%
BGD40
CE / F CE / F
T. HOMOLOG . HOMOLO
LE DE BAIN ET U LE DE BAIN ET
N MOBILE SI SON INSTA MOBILE SI SON INST
A Z240MH SERIE DE
DE MAISONS MANUFACTURE
CETTE NORME D'ETATS-
E RELATIVE AU CRITE
SITES ET LES COMMUNAUTES, ANSI/NFPA 501A. SI S
BCDV400-P BGD40G-P
10
N'AJOUTEZ PAS A CET APPAREIL AUCUN MATERIAU DEVANT
BGD40
7
LP
W385-0656
W415-0811 / D / 08.16.12