Cobra BRIDGE 4100 User Instructions page 20

4.9 - Alarm rearm
After disarming with the radio control, there is a delay of 40 s
within which the system rearms unless the ignition is switched
on. The count is halted if a door or the boot are opened.
4.10 - Alarm auto re - arm with door locking
This function adds automatic door locking to the alarm auto re-
arm procedure.
4.11 - Doors / bonnet / boot open signal
When the system is armed, it will signal by buzzing and direction
indicator flashes (3 buzzer signals and 5 flashes) if a a door or
the bonnet or boot is open. If they are closed within 23 s, any
subsequently door / bonnet / boot opening will trigger these
signals. If the 23 s elapse without closing the door / bonnet /
boot, the system will not check their status again until another
closing / opening operation occurs that triggers an alarm
4.12 - Blinker arming / disarming
Two flashes from the turn indicators indicate that the system is
armed, one flash that it is disarmed.
If the system is deactivated, the turn indicators will only flash
when an alarm cycle is triggered.
4.13 - Buzzer
Provides an acoustic signal in synchronism with the turn indicators
when the system is armed or disarmed.
20
06DE2142E.pmd
.
20
4.14 - Buzzer during Car Finder procedure
Signals the car finder function in synchronism with the turn
indicators.
4.15 - Automatic anti - robbery protection
This mode requires a user recognition procedure whenever the
ignition is turned on and every time the door is opened while
the ignition is on. Activation of the anti - robbery mode is
signalled by a long flash of the LED.
User recognition can be performed by the following means:
• correct entry of the first two digits of the PIN code;
• contact of the Jack key for 1 s with the emergency panel (if
self - learned);
• reception of the Driver Card signal (if self - learned).
Recognition is confirmed by a long flash of the LED and enables
normal use of the vehicle. Recognition must occur within 60 s
after anti - robbery protection has been activated. If recognition
does not occur within the next 30 s, the radio controls are
disabled. If recognition does not occur within 60 s, 9 alarms
cycles lasting 30 s are generated, at the end of which the
system is armed without the engine lock (if the ignition is
switched off the alarm stops sounding the system remains armed
and the engine is immediately immobilised).
To disarm the system when in anti - robbery alarm state it is
necessary to key in the entire PIN Code.
4.16 - Voluntary anti - robbery protection
This mode allows the user to activate the function voluntarily
by pressing radio control key "B" with the ignition turned on.
11/02/2008, 11.15
Basic Function - BRIDGE 4100