Cobra BRIDGE 4100 User Instructions page 21

Activation of the anti - robbery function is signalled by quick
flashing of the LED. Whenever a door is opened while the
ignition is on, this activates the anti - robbery mode and the
LED is turned off.
User recognition can be performed by the following means:
• correct entry of the first two digits of the PIN code;
• contact of the Jack key for 1 s with the emergency panel (if
self - learned);
• reception of the Driver Card signal (if self - learned).
Recognition is confirmed by a long flash of the LED and enables
normal use of the vehicle. Recognition must occur within 60 s
after anti - robbery protection has been activated. If recognition
does not occur within the next 30 s, the radio controls are
disabled. If recognition does not occur within 60 s, 9 alarms
cycles lasting 30 s are generated, at the end of which the
system is armed without the engine lock (if the ignition is
switched off the alarm stops sounding the system remains armed
and the engine is immediately immobilised).
To disarm the system when in anti - robbery alarm state it is
necessary to key in the entire PIN Code.
BRIDGE 4100 - Basic Function
06DE2142E.pmd 21
4.17 - Autohazard
If activated, the system turns on the four hazard lights if the
vehicle's speed drops by 50% in one s.
4.18 - Speed Alert
If the function is activated, the buzzer will warn in the vehicle
exceeds the speed limit. To memorize the speed limit, press
button "A" on the radio control when the vehicle is being driven
at the limit speed. To deactivate the function, press button "B"
on the radio control when the vehicle is on the move.
It's possible to active / deactive the function by extended pressure
of the control panel push button.
11/02/2008, 11.15
21