Use Of The Nutri Ninja Cups - Ninja BL48X series Owner's Manual

Use of the Nutri Ninja
WARNING: Never leave the appliance unattended while in use.
CAUTION: Pro Extractor Blades
Extractor Blades, do not hold the blades, always hold by the base of the blade assembly.
CAUTION: CAUTION: DO NOT BLEND HOT LIQUIDS. Allow the liquids and foods to cool to room temperature
before blending.
CAUTION: Do not put hot liquids in the Stainless Steel 650 ml Ninja Cup before blending. Start with cool
or room temperature liquid. Heated liquid can create internal pressure in a sealed cup, which may erupt
on opening and cause a burn injury.
IMPORTANT: Make sure that the motor base is plugged in for use.
IMPORTANT: When processing soft dry ingredients such as day-old bread or cheese use quick, short 1
second pulses. Do not overfill to avoid overheating the appliance. Allow the appliance to cool after each use.
ASSEMBLY
or or
Fig. 1
1
Place the motor base on a clean, dry, level surface such
as a counter or table top. Press down on the motor
base to make sure that the suction cups adhere to the
counter or table top.
2
Make sure that the motor base is plugged in for use.
Lights will not yet illuminate.
3
Add ingredients to the cup.
NOTE: Do not overfill! to avoid spilling, do not add
ingredients past the "MAX" fill line.
4
Place the Pro Extrator Blades onto the cup and twist it
on tightly until you have a good seal. (Fig. 1)
5 Turn the cup upside down and place it onto the motor
base, aligning the tabs on the cup with the motor base.
Turn it clockwise, until you feel it click into place. The
Timer light will illuminate. (Fig. 2)
6 Press one of the buttons to activate. (Fig. 3)
NOTE: When using the Auto-iQ
operate using pulses, pauses and continuous runs. The
pauses allow the contents of the cup to settle. When
the timer reaches "0", it will stop by itself.
Cups
®
are sharp and removable, handle with care. When handling the Pro
™
Fig. 2
presets, the unit will
®
USE
Fig. 3 Fig. 4
7
To remove the cup, ensure that the motor has stopped
running. Then turn the cup anticlockwise (Fig. 4) and
pull straight up to remove. (Fig. 5)
8
Turn the cup upright and remove the Pro Extrator
Blades by twisting the Pro Extrator Blades
anticlockwise. Be sure to store the Pro Extrator Blades
attached to an empty cup when not in use.
9
Twist the Sip & Seal
®
drink on the go. Press flip top cap firmly into the
opening to get the best seal. The flip top cap locks open
when pressed backward.
NOTE: Sip & Seal lid not intended for use with the XL
Multi-serve 1.4 L Ninja Jar.
10 Make sure that the motor base is unplugged when not
in use.
11 To remove the motor base unit, tip the unit forward
from the rear to easily disengage the suction cups.
www.sharkninjamanuals.com
REMOVAL
Fig. 5
lid onto the cup to enjoy your
8