Measuring Blood Pressure - Beurer BM 58 Instructions For Use Manual

Note: In 24h mode, the date is displayed as day/month. In
12h mode, as month/day.
Operation with the mains part
You can also operate this device with a mains part.
When doing so, there must not be any batteries in the bat-
tery compartment. The mains part can be obtained from
specialist retailers or from the service address using order
number 071.60.
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains part
described here.
• Insert the mains part into the connection provided for
this purpose on the right-hand side of the blood pressure
monitor. The mains part must only be connected to the
mains voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the
mains socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains part, the blood pressure monitor loses the date
and time setting but the saved measurements are retai-
ned.

5. Measuring blood pressure

Please ensure the device is at room temperature before
measuring.
Positioning cuff
Fit the cuff round your bare left
upper arm. Blood circulation in the
arm should not be restricted by
tight clothing or other objects.
The cuff should be placed on the
upper arm so that the lower edge
is 2 to 3 cm above the bend of the
elbow and above the artery. The
tube should be in line with the
centre of the palm.
Now place the free end of the cuff
snugly, but not too tightly, around
the arm, and fix it with the Velcro
fastener. The cuff should be fitted
tight enough to allow just two
fingers to fit beneath the cuff.
23