Cleaning And Storage - Beurer LW 110 Instructions For Use Manual

Hide thumbs Also See for LW 110:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 10
Graphic displayed
The air washer is switched off by pressing the "On/off" button
Regularly check the water level gauge during operation and refill the tub if necessary.
Note:
• The actual humidification output depends on the ambient conditions and the air contact with the
humidification discs. In principle, the lower the relative air humidity, the higher the humidification,
and the greater the damp contact surface with the air, the higher the humidification.
• The LCD illumination reduces 5 seconds after a button has been pressed. The reduced display
illumination enables the device to be operated in bedrooms.
• Use fan level 1 to operate the device during the night.

7. Cleaning and storage

WARNING
• Unplug the device each time before cleaning.
• Clean the device using only the methods specified. Under no circumstances must liquid enter the
fan unit.
• Do not use any solvent-based cleaning products.
• Use only the cleaning solution from the manufacturer.
Rinsing the tub
Rinse out the tub every 2 weeks with clean water. If the air is heavily polluted, the device is used intensively
or the water quality is poor, the air washer must be cleaned at shorter intervals. If necessary, remove any
deposits in the tub using a plastic brush.
Regular cleaning is a prerequisite for hygienic and fault-free operation.
The air washer can be dismantled easily and without tools for cleaning.
Always empty and thoroughly clean the air washer if the device contains water and has not been operated
for longer than 3 days.
Cleaning the fan unit
You can wipe the fan unit with a damp cloth. However, make sure that no liquid enters the fan unit.
Cleaning the upper cover
Remove the fan unit to more easily clean the upper cover. To do so,
slide the 4 locks to the outside and remove the fan unit.
Important: When putting the fan unit down, ensure that it does not
come to rest on the water level sensor.
Fill level
enGLIsH
Residual water in tub.
The tank must be refilled.
Device automatically switches off after 6 hours.
The device has switched itself off due to safety reasons. Clean and refill the
device before next use.
on the upper side.
15

Advertisement

Table of Contents
loading

Table of Contents