How To Program Functionalities, Cobra Remote Controls And Driver Cards Self; Learning Procedure - Cobra 4600 CAN Installation Manual

8 - HOW TO PROGRAM FUNCTIONALITIES, COBRA REMOTE CONTROLS AND DRIVER CARDS
SELF LEARNING PROCEDURE.
IMPORTANT: (only for PLIP applications and just after the power supply connection or when the battery has
been disconnected and reconnected). Before entering in the functions programming procedure, arm the system,
wait until the emergency panel LED starts fl ashing, then disarm the system. From now on it will be possible to
performe the programming procedure.
PROCEDURE:
a. Open the driver side door.
b. Open the bonnet.
c. Connect the main unit blue wire to GND (only
when a wireless siren is fi tted).
d. Turn the ignition key ON.
e. Enter the four Pin Code digits.
f. A fl ashing of the direction lights will confi rm
you've entered in the programming procedure
PROCEDURE:
a. Open the driver side door.
b. Open the bonnet.
c. Connect the main unit blue wire to GND (only
when a wireless siren is fi tted.
d. Turn the ignition key ON.
e. Enter the four PIN code digits.
f. A fl ashing of the direction lights will confi rm
you've entered in the programming procedure.
g. Turn the ignition key OFF, then turn it ON. Two
fl ashes of the direction lights will confi rm you've
entered in the programming page 2.
INSTALLATION MANUAL 4600 CAN/PLIP
Arming / disarming "buzzer" setting and buzzer volume
Important: its activation is forbidden for CE countries.
g. Push the emergency panel pushbutton until you've reached the
required volume. You can set seven different levels, at the next step the
volume will be excluded. Pressing again you will start from the beginning.
h. To exit the procedure close the bonnet or disconnect the blue wire of the
main unit from GND.
Self learning procedure for new Cobra remote controls
and/or Driver Cards (if provided).
Important: to properly perform the procedure leave the antenna
connected to the main unit.
h. Enter the four PIN code digits again to enter in the programming area for
the system control devices. If no further action is done in the following 30 s
the system will exit the procedure.
i. Press the pushbutton A of the remote control or of the Driver Card to store
them in the system, after few seconds the emergency panel LED will make a
quick fl ash to confi rm that the new remote control or the Driver Card has been
added to the system. All the control devices already stored in the system before
entering this procedure must be stored again.
l. If you want to store other remote controls or Driver Cards repeat the procedure
at point "i". The system can store maximum 4 control devices .
m. To exit the procedure disconnect the main unit blue wire from GND or
close the bonnet.
Detection of the devices connected to the COBRA BUS.
h. Wait 3 s to allow the main unit to automatically detect the devices connected
to the Cobra bus.
i. Turn the ignition key ON and OFF 5 times to reach the programming page
7, seven fl ashes of the direction lights will confi rm you've entered in the page.
WARNING: double check if the direction lights are fl ashing
7 times than wait for one LED fl ashes before turning the
ignition key OFF.
l. To exit the procedure disconnect the main unit blue wire from GND or
close the bonnet.
PIN CODE customization.
h.Enter the new four PIN code digits.
i.Turn the ignition key OFF, then turn it ON again.
l. Enter again the new four PIN code digits.
m.Five fl ashes of the direction lights will confi rm you the new PIN code has
been stored.
n.To exit the procedure disconnect the main unit blue wire from GND or
close the bonnet.
adjustment.
20