Cobra GLOBE 4800 CAN Fitting Instructions Manual page 12

INTRODUCTION
This manual contains all the information necessary to install the alarm system and to set it up
as required by the customer and/or by the local/insurance directive.
Refer to the user manual for a description of each function.
Each function is described in the user manual, while in this manual you will find some suggestions
to follow during the installation.
Standard functions list
Here listed are the main functions of the alarm. It is not possible to activate/deactivate and
personalize them.
• arm and disarm via vehicle original remote radio control.
• perimetric protection. An alarm condition is triggered if a door, boot or bonnet is opened.
There is a 40 s set up delay, after arming the system, before the sensors are active.
• hotwire protection. When armed, the immobilizer is active and any attempt at starting triggers
an alarm condition.
• when the alarm is triggered the electronic siren sounds for 30 s at more than 115 dB (@ 1m)
and the turn indicators flash.
• alarm status LED wich displays also alarm status history.
• safety circuit that ensures that the alarm cannot be armed while the vehicle's engine is running.
• volumetric ultrasonic sensor exclusion.
• emergency override (PIN code, it is possible to personalize).
• battery back up protection.
Basic functions list (programmable)
There are functions that need to be programmed to suit the vehicle model and the alarm operating
modes required.
Refer to the BASIC FUNCTIONS TABLE of the programming tables.
• buzzer volume regulation.
• volumetric protection of the passenger compartment with two adjusting modes.
• signal of opened doors/bonnet/boot.
• arm/disarm blinker.
• alarm automatic arming.
• immobilizer automatic arming (4818/4918 only).
• immobilizer alarm.
GB
12
06DE2178A SEGN.pmd 12
FITTING INSTRUCTIONS GLOBE 4800/4900 CAN
Lista de las funciones avanzadas (programables)
Son funciones particulares que requieren ser programadas según la modalidad de funcionamiento
de la alarma deseada.
Tomar como referencia la TABLA FUNCIONES AVANZADAS de los esquemas de programación.
• antidistracción inmovilizador (sólo 4818/4918).
• antidistracción alarmas.
• entrada puertas positivo
• conexión 2110 activada
• habilitación Pin code 1111
• seleccion bocina (salida alternada)
• seleccion altoparlante
• seleccion sirena
ATENCIÓN !
Este producto está configurado para cumplir con los requisitos de la Directiva Europea para
los sistemas de alarmas. La utilización de la función buzzer está permitida sólo en los mercados
que no forman parte de la CE.
La activación anula la homologación.
Antes de comenzar la instalación desconectar el cable negativo de la batería y volverlo
a conectar recién cuando la instalación se ha concluido.
Este sistema es compatible con vehículos automotores que tengan una batería de 12 V con
negativo a masa.
GLOBE 4800/4900 CAN MANUAL DE INSTALACIÓN
17/11/2005, 14.38
E
29