Applying Power To The Alero Amplifier; Ac Power Plug Connector; Entering Standby Mode - AMX ALR-AMP-8 Instruction Manual

Applying Power to the Alero Amplif ier
CAUTION:
damage to the internal components and a possible burn out.
CAUTION:

AC Power Plug Connector

The following table provides pinout information for the AC Connector:
AC Power Plug Connector - Pinout Information
PIN Function
1 Live
2 Neutral
3 PE
Mains Power Fuse - T6.3A H Mains Power Fuse fuse provides over-current protection.

Mains Power Switch - The power switch is the AC mains switch, which turns everything off when it is in the Off position,

and powers everything on when it is in the On position.
1. Connect a standard IEC 3-pole detachable power cord to the AC Mains power connector on the rear panel.
2. Plug the attached power plug into a correctly grounded wall outlet.
3. Switch the Mains Power Switch (on the rear panel) to the On position.
Note that the POWER LED on the front panel lights Green to indicate that the amplifier is receiving power (and not in Standby
mode).

Entering Standby Mode

To put the Alero Amplifier in Standby Mode:
Remove signal from the signal sense input, or disable signal sense input. See the Pin 1 - Signal Sense section on page 15

for details.
Enable 3-5V trigger -> Disable 3-5V trigger

Note that the POWER LED on the front panel lights Red to indicate that the amplifier is receiving power, but is in Standby mode.
Also note that when in Standby mode, the 12V output trigger is turned off.
ALR-AMP-8 Alero 8 Zone Power Amplifier - Instruction Manual
This unit should only have one source of incoming power. Using more than one source of power to the Alero can result in
Apply power to the unit only after installation is complete.
Description
Mains AC Live
Mains AC Neutral
Protective Earth
Type
Input
Input
Input
Installation
19