Connecting Speakers
All speaker connections must use Class 2 Wiring.
NOTE: All speaker connections must use Class 2 Wiring. Class 2 Wiring is required due to the fact that power is above 10W per
channel under normal operating conditions.
Speakers connect to the captive-wire output terminals (CH1-CH16) on the rear panel (FIG. 7): t
Zone 1
outputs
(CH1/CH2)
Zone 5
outputs
(CH9/CH10) (CH11/CH12) (CH13/CH14)(CH15/CH16)
Speaker (Output) Terminals (16 total, L/R pairs for eight stereo outputs)
FIG. 7
Each Zone (1-8) consists of two channels (an L/R pair in Stereo Mode), and each Channel (1-16) uses a 2-pin captive-wire
connector to connect to speakers.
NOTE: For wiring runs longer than 80 feet, 14-gauge speaker wire is recommended.
Speaker Output Connectors
The speaker output connectors consist of two 16 pin captive-wire terminals; each of the output terminals having a
"+" and "- " terminal.
The label "BTL" on each speaker pair points to the pins that are used when connecting a single speaker to an input in Bridge Mode
(see SE/BTL (Stereo/Bridge Mode) Switches (1-8) on page 10).
See the Connecting Input Devices in Bridge Mode section on page 11 for details.
See the Connecting Speakers section on page 12 for connection details.
The following table provides pinout information for the Speaker Output Terminals
Speaker Output Terminals Pinout Information
PIN
Function
1
OUT+
2
OUT-
ALR-AMP-8 Alero 8 Zone Power Amplifier - Instruction Manual
Zone 2
Zone 3
Zone 4
outputs
outputs
outputs
(CH3/CH4)
(CH5/CH6) (CH7/CH8)
Zone 6
Zone 7
Zone 8
outputs
outputs
outputs
Description
Positive balanced audio power output terminal
Negative balanced audio power output terminal
Odd numbered outputs = left channel (in Stereo Mode)
Even numbered outputs = right channel (in Stereo Mode)
Zone 1 = CH1/CH2
Zone 2 = CH3/CH4
Zone 3 = CH5/CH6
Zone 4 = CH7/CH8
Zone 5 = CH9/CH10
Zone 6 = CH11/CH12
Zone 7 = CH13/CH14
Zone 8 = CH15/CH16
Type
Output
Output
Installation
12