Care And Cleaning - Dometic WDCVLW Installation Instructions And User Manual

CARE AND CLEANING

WARNING! Failure to obey the following in-
structions could result in death or serious injury due
to fire or explosion.
● Read and understand all safety instructions.
● Before attempting maintenance, disconnect the
power and shut the water valves off.
● Do NOT use unapproved cleaning solvents that
may damage the laundering machine and gener-
ate toxic gases which can explode.
● NEVER spray water on the laundering machine
to clean it.
● Any detergents containing PCMX should NOT be
used to clean the machine.
● Cleaning the Appliance Cabinet
● Proper maintenance of the appliance can
extend its working life. The surface can be
cleaned with a diluted non-abrasive detergent
when necessary. If there is any water overflow,
use a wet cloth to wipe it off immediately. No
sharp items should be used on the cabinet.
NOTE: Do NOT use any acid, diluted solvents,
or equivalent substances to clean the cabinet.
● Cleaning the Internal Drum
● Any rust left inside the drum by metal articles
MUST be removed immediately with chlorine-
free detergents. NEVER use steel wool or any
other abrasive cleaning materials.
● Removing the Remaining Water in the Inlet
Hose
CAUTION! Burn Hazard. This step should be
completed after the hot water inside the machine
cools down.
1. Turn off the tap.
2. Unscrew the inlet hose from the tap and
put its end into a large container to catch
the water.
3. Start any cycle except the Single Wash
or Drain procedure.
4. If there is any water, it will be drained out
of inlet hose for about 40 seconds.
5. Reconnect the inlet hose to the tap.
6. Remove the remaining water in the drain
pump.
● Cleaning the Detergent Dispenser and Grooves
1. Remove the drawer.
2. Remove the softener post cover, wash
thoroughly, and replace.
● Cleaning the Inlet Filter
● The filter MUST be cleaned if there is little or
no water flow when the tap is opened.
● Cleaning the Tap Filter
1. Turn off the tap.
2. Select any cycle except "Wash" or "Drain".
3. Press the "Start/Pause" button and keep
the cycle running for approximately 40
seconds.
4. Remove the inlet hose from the tap.
5. Use water to wash the filter if present.
6. Reconnect the inlet hose.
15
FIG. 18
FIG. 19
FIG. 20