Cub Cadet 930 SWE Operator's Manual page 27

6. Lift the friction wheel assembly out between the axle
shaft and the drive shaft assemblies.
7. Remove four screws securing the friction wheel to the
hub assembly (refer to Fig. 8-11). Discard old friction
wheel.
Figure 8-11
8. Reassemble the new friction wheel onto the hub
assembly, tightening the four screws in rotation and
with equal force. It is important to assemble the friction
wheel symmetrically for proper functioning. Refer to
Fig. 8-11.
9. Reposition the friction wheel assembly in the snow
thrower frame. Insert the pin from the shift arm
assembly into the friction wheel assembly and hold
assembly in position. Refer to Fig. 8-12.
Figure 8-12
10. Slide the hex shaft through the right side of the frame
toward the left side and through the friction wheel
assembly.
If the sprocket fell from the snow thrower chain
NOTE:
while removing the hex shaft, position the hex hub of the
sprocket toward the friction wheel and place the sprocket
in the chain.
11. After making certain that the chain is on both the large
and the small sprocket, align the hex shaft with the hex
hub of the small sprocket, and slide the shaft through
the sprocket.
12. Slide the spacer onto the end of the hex shaft.
13. Align the bearing on the right end of the hex shaft with the
hole in the right side of the frame, then push the hex
shaft to the left into position in the frame.
14. Slide the bearing onto the left end of the hex shaft and
press into the hole on the left side the frame.
15. Place the belleville washer (rounded side toward head)
onto the hex screw removed earlier, and insert the
screw into the threaded hole of the hex shaft.
16. Gradually tighten the hex screw to fully seat the bearings
in each side of the frame and to secure the hex shaft.
17. Position the frame cover on the bottom of the frame and
secure with the self-tapping screws. Pivot the snow
thrower down to its normal operating position.
IMPORTANT: Repeat the drive control test from the Set-Up
& Assembly section of this manual before operating the
snow thrower.
s 8 — s 27
ectiOn ervice