Cub Cadet 930 SWE Operator's Manual page 11

Shave Plate
Figure 3-10
Auger and Drive Control Cables
WARNING!
Prior to operating your snow thrower,
carefully read and follow all instructions below.
Perform all adjustments to verify your snow thrower is
operating safely and properly.
Testing Auger Drive Control
1. When the au ger control is released and in the disengaged
"up" position, the cable should have very little slack. It
should NOT be tight. Refer to Figure 3-11.
Chute Tilt Control
Auger
Control
Auger
Control
Cable
Figure 3-11
2. In a well-ventilated area, start the snow thrower engine as
instructed in the Operation section of this manual. Make
sure the throttle is set in the FAST position.
3. While standing in the operator's position (behind the snow
thrower), engage the auger.
4. Allow the auger to remain engaged for approximately ten
(10) seconds before releasing the auger control. Repeat this
several times.
5. With the throttle control in the FAST (rabbit) position and
Lower
the auger control in the disengaged "up" position, walk to
Shave
the front of the machine.
Plate
6. C
and shows NO signs of motion. If the auger shows ANY
signs of rotating, immediately return to the operator's
Raise
position and shut off the engine. Wait for ALL moving parts
Shave
to stop before re-adjusting the auger control.
Plate
Testing Drive Control & Shift Lever
1. With the engine turned off, move the speed selector lever
into sixth (6) position. Refer to Figure 3-11.
2. With the wheel drive control released, push the snow
thrower forward, then pull it back. The machine should
move freely.
3. Engage the drive control and attempt to move the machine
both forward and back, resistance should be felt.
4. Move the shift lever into the fast reverse (R2) position and
repeat the previous two steps.
5. If you experienced resistance rolling the unit, either
when repositioning the shift lever from 6 to R2 or when
attempting to move the machine with the drive control
released, adjust the drive control immediately. See
Speed Selector Lever
Adjusting Drive and Auger Controls.
Drive
Control
Drive
Control
Cable
onfirm that the auger has completely stopped rotating
s 3 — a
ectiOn
& s -u 11
sseMbly et p