Cub Cadet 930 SWE Operator's Manual page 17

Recoil Starter
CAUTION!
Do not pull the starter handle while the
engine running.
WARNING:
To avoid unsupervised engine
operation, never leave the engine unattended while
running. Turn the engine off after use and remove
key
1. Insert key fully into slot, Figure 5-5. Make sure it snaps into
place. DO NOT turn key. The engine cannot start unless the
key is inserted into ignition switch.
2. Move throttle control to FAST (rabbit) position.
3. Move choke to the CHOKE position (cold engine start). If
engine is warm, place choke in RUN position.
4. Push primer three times, making sure to cover vent hole
when pushing. If engine is warm, push primer only once.
Always cover vent hole when pushing. Cool weather may
require priming to be repeated.
5. Pull gently on the starter handle until it begins to
resist, then pull quickly and forcefully to overcome the
compression. Do not release the handle and allow it to
snap back. Return rope SLOWLY to original position. If
required, repeat this step.
6. As the engine warms, slowly rotate the choke control to
RUN position. If the engine falters, restart engine and run
with choke at half-choke position for a short period of time,
and then slowly rotate the choke into RUN position.
Stopping the Engine
WARNING:
To avoid unsupervised engine
operation, never leave the machine unattended
with the engine running. Turn the engine off after
use and remove key
Run engine for a few minutes before stopping to help dry off any
moisture on the engine.
1. Move throttle control to STOP position.
2. Remove the key. Removing the key will reduce the
possibility of unauthorized starting of the engine while
equipment is not in use. Keep the key in a safe place. The
engine cannot start without the key.
3. Wipe any moisture away from the controls on the engine.
To Engage Drive
1. With the throttle control in the Fast (rabbit) position, move
shift lever into one of the six forward (F) positions or two
reverse (R) positions. Select a speed appropriate for the
snow conditions and a pace you're comfortable with.
NOTE: Use slower speeds in higher snow and/or until you
are familiar with the snow thrower operation
2. Squeeze the drive control against the handle the snow
thrower will move. Release it and drive motion will stop.
CAUTION:
NEVER move the shift lever without first
releasing the wheel drive control. Doing so will
cause premature wear on the drive system's friction
wheel
3. To turn the snow thrower to the left or right, squeeze the
respective wheel steering control. Refer to Figure 4-1.
To Engage Augers
1. To engage the augers and start throwing snow, squeeze
the auger control against the left handle. Release to stop
the augers.
2. While the auger control is engaged, squeeze the drive
control to engage the interlock mechanism and to drive
the snow thrower. The interlock mechanism locks the
auger control so you can turn the chute control without
interrupting the snow throwing process.
3. Release the auger control; the interlock mechanism should
keep the auger control engaged until the drive control is
released.
4. Release the drive control to stop both the augers and
the wheel drive. To stop the auger, both levers must be
released.
s 5 — O
ectiOn peratiOn
17