Table of Contents
Advertisement
6
102
• Align clamp 3 on the end
silencer with the mark A
(arrow) on Lambda oxygen
sensor B.
• Tighten clamp 3 on the end
silencer to the appropriate
tightening torque.
• Fit bolt 4 of the end silencer
bracket to the pillion footrest
and tighten to the correct
tightening torque.
If the gap between the
rear wheel and the end
silencer is too small, the rear
wheel can overheat.
The gap between the rear
wheel and the end silencer
must be at least 10 mm.c
• Push silencer cover 2 with
guides A into the brackets B.
• Fit bolt 1 and tighten to the
appropriate tightening
torque.
• Remove any auxiliary stand.
Advertisement
Table of Contents
