Page 1
1200 will easily accommodate the FT 1200 will not work correctly with the FT 1200 case. Note When the FC-40 is connected to the FT 1200 TUNER jack and the LINEAR LINEAR 12 00 O Page 14 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 3
100 or pseudo-straight-key operation. memories for instant automatic recall later when the of the transmit line. 12 00 O Page 16 PERATING ANUAL YAESU MUSEN CO., LTD.
[ IPO ] button to provide two stages of signal reduc- tion when an extremely strong signal is being re- ceived. [ R.FLT ] ( R ) Switch OOFING ILTER microphone. When engaging the [ MOX ] DVICE 12 00 O Page 17 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 5
TFT display whenever the [ PROC/CAR ] outer 176 TX MAX POWER [ PROC ] In the SSB mode the value will be shown 12 00 O Page 18 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 6
MODE [ WIDTH ] knob to set the overall rotation increases the bandwidth. The current band- IF passband for 3 seconds whenever the [ WIDTH ] knob is turned. 12 00 O Page 19 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 7
[ AUTO ] Switch initiate continuous sweeping. [ MENU ] Switch various transceiver characteristics may be config- manual. MPORTANT [ MENU ] [ MENU ] button to save any con 12 00 O Page 20 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 8
[ TXW ] ( TX Watch ) Switch [ RCL ] (Recall) Button [ RCL ] [ C.S ] Switch [ C.S ] press the [ MENU ] the [ C.S ] [ MENU ] 12 00 O Page 21 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 9
10 seconds. [ V/M ] the double beep) copies the current operating data writing any previous data stored there. icon will no longer be displayed. 12 00 O Page 22 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 10
Numbers in parentheses indicate steps when the [ FAST ] button is On. DVICE [ FAST ] Switch rate. 150 CW DIAL STEP 154 SSB DIAL STEP [ LOCK ] Switch 12 00 O Page 23 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 11
Clarifier register [ CLEAR ] [ VFO-B/CLAR ] knob button. [ VFO-B/CLAR ] change the tuning rate of the [ VFO-B/CLAR ] knob the TFT display. 12 00 O Page 24 PERATING ANUAL YAESU MUSEN CO., LTD.
[ VFO-B/CLAR ] [ MHz/μT ] switch for [ MCH/GRP ] Switch channel using the [ VFO-B/CLAR ] knob. group by turning the [ VFO-B/CLAR ] knob. [ VFO-B/CLAR ] Knob 12 00 O Page 25 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 13
NB ( OFF, ON, ON [ NBW ]) : panel [ NB ] button. AGC ( SLOW, FAST, MID ) : lected by the front panel [ AGC ] switch. 12 00 O Page 26 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 14
This indicator toggles the internal CW keyer on and front panel’s [ MIC/SPEED ] knob and the CW Hang 062 CW BK-IN DELAY [ ZIN/SPOT ] (see page 81) This indicator enables the CW receiver spotting tone. 12 00 O Page 27 PERATING ANUAL YAESU MUSEN CO., LTD.
[ LOCK ] Indicator knob is locked. Frequency Display LSB, USB, CW, AM, FM, RTTY, DATA [ MODE ] button in the indi- vidual operating modes for approx. one second to 12 00 O Page 28 PERATING ANUAL YAESU MUSEN CO., LTD.
μ-TUNE Jacks switching device. Its function is identical to the [ MOX ] button on the front panel. The same line is available at the RTTY/PKT 12 00 O Page 29 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 17
The audio output impedance at this jack is 4 - 8 the front panel [ AF ] knob. Inserting a plug into this jack disables the internal loudspeaker. 12 00 O Page 30 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 18
[ ] , [ ] , [ ] , [ ] Switches ] buttons to change the [ DEC ] Switch [UP DWN ] buttons to these buttons are used to move the cursor and select the text characters. 12 00 O Page 31 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 19
FCC ID: K6620581X50 / IC: 511B-20581X50 ASIC PERATION ECEIVING ON MATEUR ANDS Have you made all ground connections [ AF ] 1200 O Page 32 PERATING ANUAL YAESU MUSEN CO., LTD.
Page 20
[ BAND ] key corresponding to In the LSB or USB modes and holding the [ MODE ] button toggles between tion. DVICE DVICE The FT 1200 065 CW FREQ DISPLAY even 1200 O Page 33 PERATING ANUAL YAESU MUSEN CO., LTD.
Need help?
Do you have a question about the FTDX1200 and is the answer not in the manual?
Questions and answers