Memory; Dimms; Ddr4-Sdram Dimms; Populating Dimm Sockets - HP ProDesk 600 G2 Series Maintenance And Service Manual

Memory

Description
16-GB, PC4-17000
8-GB, PC4-17000
4-GB, PC4-17000
The computer comes with double data rate 4 synchronous dynamic random access memory (DDR4-SDRAM)
dual inline memory modules (DIMMs).

DIMMs

The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These
memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory
support, you can populate the system board with up to 64-GB of memory configured in a high-performing
dual channel mode.

DDR4-SDRAM DIMMs

For proper system operation, the DIMMs must be:
● industry-standard 288-pin
● unbuffered non-ECC PC4-17000 DDR4-2133 MHz-compliant
● 1.2 volt DDR4-SDRAM DIMMs
The DIMMs must also:
● support CAS latency 15 DDR4 2133 MHz (15-15-15 timing)
● contain the mandatory JEDEC SPD information
In addition, the computer supports:
● 512-Mbit, 1-Gbit, and 2-Gbit non-ECC memory technologies
● single-sided and double-sided DIMMs
● DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported
NOTE: The system will not operate properly if you install unsupported DIMMs.

Populating DIMM sockets

There are four DIMM sockets on the system board, with two sockets per channel. The sockets are labeled
DIMM1, DIMM2, DIMM3, and DIMM4. Sockets DIMM1 and DIMM2 operate in memory channel B. Sockets DIMM3
and DIMM4 operate in memory channel A.
The system will automatically operate in single channel mode, dual channel mode, or flex mode, depending
on how the DIMMs are installed.
NOTE: Single channel and unbalanced dual channel memory configurations will result in inferior graphics
performance.
24 Chapter 4 Removal and replacement procedures – Microtower (MT) chassis