Drive Positions; Removing A 9.5 Mm Slim Optical Drive - HP ProDesk 600 G2 Series Maintenance And Service Manual

Drive positions

1 9.5mm slim optical drive bay
2 3.5-inch secondary hard drive bay
3 3.5-inch primary hard drive bay
NOTE: The drive configuration on your computer may be different than the drive configuration shown above.
To verify the type and size of the storage devices installed in the computer, run Computer Setup.

Removing a 9.5 mm slim optical drive

1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the power cable and data cable from the back of the optical drive.
CAUTION:
damaging the cable.
(Access panel on page
(Front bezel on page
When removing the cables, pull the tab or connector instead of the cable itself to avoid
(Preparation for disassembly on page
20)
21)
19)
Drives 33