Remote Controller Compliance Version - dji PHANTOM 4 User Manual

Phantom 4 User Manual
4. The remote controller is ready to link. The Remote Controller Status Indicator blinks blue and a beep is
emitted.
RC Calibration
Stick Mode
Default stick mode is Mode 2, changing stick modes alters the way the aircraft is controlled.
Do not change unless familiar with your new mode.
Button Customization
You can customize the C1 and C2 buttons on the back of the RC.
5. Locate the linking button on the side of the aircraft, as shown in the figure below. Press the link button
to start linking. The Remote Controller Status Indicator LED will display a solid green once the remote
controller is successfully linked to the aircraft.
The remote controller will un-link itself from an aircraft if a new remote controller is linked to the
same aircraft.

Remote Controller Compliance Version

The remote controller is compliant with both CE and FCC requirements.
36
©
2016 DJI. All Rights Reserved.
RC Control Setting
Searching for aircraft frequency,
timeout in 54 seconds
Press the linking button on the aircraft
to link this remote controller
C1 Not Defined
Cancel
C2 Not Defined
Linking RC
Link Button