Table of Contents
Advertisement
Names and Functions
Rear panel
1. Analog unbalance output terminals
(LINE)
Coaxial output terminals to provide unbalanced playback
signals of this unit
Connect these terminals to an unbalanced input of such
device as a pre-amplifier with a pin cable.
The phase can be switched with the analog output phase
selection switch (PHASE INVERT) on the front panel.
2. Analog balance output terminals
(BAL LINE)
Cannon connector output terminal to provide balanced
playback signals from this unit
Connect these terminals to a balanced input of an output
device such device as a pre-amplifier with a balanced cable.
The following are the phases of the output terminals of this
unit:
[Normal Position]
1. GROUND
2. COLD (–)
3. HOT (+)
[Invert Position]
1. GROUND
2. HOT (+)
3. COLD (–)
19
1
3
2
4
5 6 7
3. Optical digital input terminal (OPT)
8
9
When using this unit as a D/A converter, transmit digital sig-
nals from a CD player or the like that has a digital output
terminal to this unit using an optical digital cable.
The terminal is applicable to the following signals.
Sampling frequency
: 32kHz, 44.1kHz, 48kHz,
88.2kHz, 96kHz, 176.4kHz,
192kHz
Number of quantization bits : 16bit, 20bit, 24bit
This terminal has a shutter. Direct the cable connector cor-
rectly when inserting the cable into the terminal. If the cable
connector is inserted forcibly with the wrong direction, the
terminal may be deformed, and the shutter may not be able
to close even after cable disconnection.
Advertisement
Table of Contents
