Turn Signal Lamps - Cadillac SRX 2010 Owner's Manual

srx.book Page 37 Monday, June 8, 2009 8:28 AM
5. Install the bulb socket in the
headlamp assembly.
6. Connect the electrical connector.
7. Install the cap with the down
arrow pointing down in the back
of the headlamp assembly.
8. For driver side, reinstall the
underhood electrical center cover
by latching three clips.
9. For passenger side, reinstall the
air filter/cleaner assembly base
by pushing to seat . Verify the
base is seated securely, then
install the engine air filter/cleaner
assembly.
Front Turn Signal Lamp (Base
and Up-Level)
To replace the Front Turn Signal
Lamp:
1. Remove the turn signal lamp bulb
socket from the headlamp
assembly.
2. Remove the turn signal lamp bulb
from the socket.
3. Replace the bulb in the bulb
socket.
4. Install the bulb socket in the
headlamp assembly.
5. For driver side, reinstall the
underhood electrical center cover
by latching three clips.
6. For passenger side, reinstall the
air filter/cleaner assembly base
by pushing to seat . Verify the
base is seated securely, then
install the engine air filter/cleaner
assembly.
9-37

Turn Signal Lamps

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
(Manual) on page 1-12 and
Liftgate (Power) on page 1-13 for
more information.
A. Push Pin
B. Taillamp Cover
2. Pull on push pin (A) to release
the taillamp cover (B).