Turn Signal Lamps - Cadillac SRX 2015 Owner's Manual

Cadillac SRX Owner Manual (GMNA-Localizing-MidEast-8087806) - 2015 -
CRC 1st Edition - 5/19/14
Daytime Running Lamp (DRL)
(Uplevel)
1. From the back side of the
headlamp assembly, remove the
bottom cap to replace the
DRL bulb.
2. Disconnect electrical connector.
3. Remove the DRL bulb socket
from the headlamp assembly.
4. Replace the bulb in the bulb
socket.
5. Install the bulb socket in the
headlamp assembly.
6. Connect the electrical connector.
7. Install the cap with the down
arrow pointing down in the back
of the headlamp assembly.
8. For the driver side, reinstall the
underhood electrical center
cover by latching three clips.
9. For the passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat. Verify
the base is seated securely, then
install the engine air filter/
cleaner assembly.
Front Turn Signal Lamp (Base
and Uplevel)
To replace the front turn
signal lamp:
1. Remove the turn signal lamp
bulb socket from the headlamp
assembly.
2. Remove the turn signal lamp
bulb from the socket.
3. Replace the bulb in the bulb
socket.
Black plate (29,1)
Vehicle Care
4. Install the bulb socket in the
headlamp assembly.
5. For the driver side, reinstall the
underhood electrical center
cover by latching the three clips.
6. For the passenger side, reinstall
the air filter/cleaner assembly
base by pushing to seat. Verify
the base is seated securely, then
install the engine air filter/
cleaner assembly.

Turn Signal Lamps

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-11.
10-29