Cadillac SRX 2010 Owner's Manual page 367

srx.book Page 71 Monday, June 8, 2009 8:28 AM
If the vehicle only has a cigarette
lighter, use the cigarette lighter.
Do not pinch the power plug cord
in the door or window.
7. Start the vehicle. The vehicle
must be running while using the
air compressor.
8. Turn the selector switch (A)
clockwise to the Air Only position.
9. Press the on/off (B) button to turn
the compressor on.
The compressor will inflate the
tire with air only.
10. Inflate the tire to the
recommended inflation pressure
using the pressure gage (C). The
recommended inflation pressure
can be found on the Tire and
Loading Information label. See
Tire Pressure on page 9-49.
The pressure gage (C) may read
higher than the actual tire
pressure while the compressor is
on. Turn the compressor off to
get an accurate reading. The
compressor may be turned on/off
until the correct pressure is
reached.
If you inflate the tire higher than
the recommended pressure you
can adjust the excess pressure
by pressing the pressure
deflation button (D), if equipped,
until the proper pressure reading
is reached. This option is only
functional when using the air only
hose (G).
11. Press the on/off button (B) to turn
the tire sealant and compressor
kit off.
Be careful while handling the tire
sealant and compressor kit as it
could be warm after usage.
12. Unplug the power plug (H) from
the accessory power outlet in the
vehicle.
13. Disconnect the air only hose (G)
from the tire valve stem, by
turning it counterclockwise, and
replace the tire valve stem cap.
9-71
14. Replace the air only hose (G) and
the power plug (H) and cord back
in its original location.
15. Place the equipment in the
original storage location in the
vehicle.
The tire sealant and compressor kit
has an accessory adapter located in
a compartment on the bottom of its
housing that may be used to inflate
air mattresses, balls, etc.