Seat Adjustment - Stamina 85-2221A Owner's Manual

OPERATIONAL INSTRUCTIONS
WEIGHT LIMITATIONS
WARNING: Serious injuries can occur from Wirk
Do not exceed listed weight limits
Never allow children to climb or hang on the Wirk
Do not lean on the desktop in any direction
LOAD ADJUSTMENT
To increase the load, turn the TENSION KNOB(57) clockwise.
To decrease the load, turn the TENSION KNOB(57) counterclockwise.

SEAT ADJUSTMENT

Proper seat adjustment is important.
1. Turn the ADJUSTMENT KNOB(36) to loosen, then pull
the ADJUSTMENT KNOB(36) to release the pin. Slide the
SEAT POST(6) until the SEAT(39) is at the proper height.
Release the ADJUSTMENT KNOB(36) making sure the
pin catches in one of the holes of the SEAT POST(6) and
tighten the ADJUSTMENT KNOB(36).
2. Sit on the seat and place your feet on the pedals. You should
be able to move through a complete pedal stroke without
locking your knees or shifting your hips on the seat. The seat
is too close to the pedals if you have more than a slight bend
in your knees at the bottom of the pedal stroke. The seat is
too far from the pedals if you have to completely straighten
your knees at the bottom of the pedal stroke. Refer to the
illustration.
CAUTION:
1. Do not attempt to adjust the seat while you are
on the Wirk
2. Always tighten the ADJUSTMENT KNOB(36)
after adjusting the seat to a new position.
Ride Workstation.
TM
TM
Ride Workstation tip-over. To help prevent tip-over:
TM
Ride Workstation
13