Removing The Unit - Medion MD 81460 Instruction Manual

Installation
Occupation of the ISO blocks
Problems due to switched cables
In some vehicle models, the standard arrangement of cables[4] and [7] n the
ISO block A (see above) are switched at the factory.
If this is the case in your vehicle, certain functions may be impaired: stations may
not be stored properly, for example.
To solve this, the red cable (switched plus) and the pink cable (permanent plus)
will need to be reversed in the ISO block.

Removing the unit

Remove the sun visor frame initially, to
uninstall the device and insert the right
and left keys in the slots on the sides of
the set. The flaps will be bent back and
you can remove the set.
10
BLOCK B Loudspeaker BLOCK A Power Supply
1 Lower right +
2 Lower right
3 Front right +
4 Front right
5 Front left +
6 Front left
7 Lower left +
8 Lower left
1
2
3
4 Continuous plus (perma
nent 12V on board voltage)
5 Car aerial (also for external
amplifiers, etc.)
6
7 Switch plus (switched for
12V voltage through ignition
key)
8 Mass