Placing The Range Hood - Vissani QR026 Use And Care Manual

Installation (continued)
6

Placing the range hood

DANGER: Turn off the power circuit breaker or the
power switch on the junction box before installing this
unit. Touching circuitry inside the range hood while it is
energized will result in death or serious injury.
DANGER: If installing this unit over a gas range, turn off
the gas at the source before installing or serving this unit.
□ Lift the range hood (A) up under the cabinet to determine
its final position. Mark the location of the four keyhole
mounting slots (1) on the underside of the cabinet.
□ Set the range hood (A) aside on a protective surface.
□ Drill four pilot holes in the locations that you marked.
□ Screw the four long tapping screws (AA) into the pilot
holes. Do not tighten the screws all the way – leave the
screw heads about 7 mm (0.28 in.) from the cabinet
surface.
□ Lift the range hood (A) into position, feeding the power
cable and the electrical wires through the power access
opening. Allow some slack in the cable and wires so that
the appliance can be moved if servicing is ever necessary.
□ Position the range hood (A) so the large end (2) of the
keyhole mounting slots (1) are over the screws (AA). Then
push the range hood (A) toward the wall so the screws (AA)
are in the neck (3) of the keyhole slots. Tighten the screws
(AA). Ensure that the range hood (A) is securely fastened to
the cabinet before releasing it.
□ If applicable, test the damper blade to ensure it rotates up
and down freely.
□ If applicable, connect the vent work to the range hood (A).
Seal the joints with duct tape to ensure an airtight fit.
□ Reconnect the power supply cable and wires to the
electrical supply. Turn the power on and ensure that all
lights and fans are operating correctly.
AA
1
A
11
Please contact 1-800-514-6729 for further assistance.
1
AA
2
1
3
H O M D E P E
AA
T O C . OM