Manufacturer; Installing The Damper; Installing The Charcoal Filter - Vissani QR026 Use And Care Manual

Installation (continued)
4

Installing the damper

NOTICE: Only install the damper if you are using a venting
system that does not already have a damper. If using the
charcoal filter for ductless installation, or if your venting
system already has a damper, skip this step.
NOTICE: If this hood replaces an existing unit, the location
of the air exhaust can vary from one manufacturer to
another. Ensure that the damper fits in the existing opening
before installing.
□ Choose to install the damper (C) either in the top
position (1) for top venting or in the back position (2)
for back venting.
□ Insert the damper (C) into the chosen hole in the range
hood (A), ensuring that the central flap (3) goes into the
hole while the two side flaps (4) remain above it.
□ Lift the lid (5) of the damper and screw the damper (C) to
the range hood (A) with the two short tapping screws (BB).
□ Seal the damper (C) to the range hood (A) on all four sides
with duct tape.
BB
A
5
BB
1
C
A
2
5
BB
C
4 3
C
5
Installing the charcoal filter
NOTICE: The charcoal filter should only be installed if you
are not using a venting system.
□ Unscrew the two screws holding the cover (1) on the
exhaust holes and remove the cover.
□ Turn over the range hood (A) and place its top on a
protective surface.
□ Unhook the charcoal filter support (2) from the support
hook (3) and pull the charcoal filter support up.
□ Place the charcoal filter (B) under the charcoal filter
support (2). Ensure that the filter is placed horizontally,
or the charcoal filter support (2) will not close properly.
□ Slide the charcoal filter support (2) to the left or right in its
braces (4) until you can re-hook it on its support hook (3).
4
10
A
1