Getting Acquainted; Battery Installation; Fast Start - Nikon StabilEes 14x40 Instruction Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 7

Getting Acquainted

1. Power on, stabilizing on
6. Power off
Handstrap can be
attached to either
side
5. MODE button
High-impact
polycarbonate
housing
LED II glows orange when ON
BOARD mode is selected.
Glowing green indicates LAND
mode is selected.
2. Eyepieces adjust for interpupillary
distance
The multi-color LED status indicator
(LED I) glows orange when the power
is turned on and when the unit is in
standby; green confirms stabilization is
active. Flashing orange and green
indicates weak batteries. Glowing red
indicates the batteries are exhausted
and should be replaced. Red flashes to
warn of a system problem.
14
100% multicoated
optics
Large light-gathering
40mm objective lenses
3. Single fingertip
focus control
Neckstrap Loop
Handgrip Bracket
4. Diopter adjustment
100% waterproof, dry nitrogen purged
Interpupillary scale
Battery compartment

Battery Installation

Fast Start

• Press the ON button (1) — the system powers up and performs a 5-second system
check
• Press the ON button (1) again, stabilization is activated
• Adjust the eyepieces (2) to match the distance between your eyes (until you see a single
round image)
• Focus left eye using focus control knob (3)
• Twist the right eyepiece (4) for any necessary diopter correction
• Select the stabilization mode — LAND or ON BOARD — that best suits your situation
by pressing the MODE button (5).
• Check focus again using only the control knob (3)
When you have finished observing, press the OFF button (6), attach the lens caps, and
return the StabilEyes to its case.
The StabilEyes operates on four AA batteries. To
install a fresh set of batteries, turn the binoculars
on their back, and slide the lock to the open
position.
Remove the battery holder and insert the
batteries. When returning the battery holder to
the binoculars, be certain to seat it properly, with
the O-ring in place, and move the slide to the
locked position. This seals the binoculars to help
keep them waterproof.
15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents