Installation - Valor Portrait 569 Ledge Front Installation Instructions Manual

Installation

tab at
the top
1. Fit the stud brackets
to the appliance's
sides (2 screws/
side). Make sure the
horizontal tabs are at
the top.
2. Fit the convection
baffle to the top of
the appliance case
(2 screws). The
convection baffle
slips under the top of
the appliance case.
3. Required for
installation
in combustible
construction. Bend
the stand-offs into
shape and fix them to
the appliance's case
as indicated (4 screws/
side, pre-fitted on
engine).
4. Required for
installation in
combustible
construction. Add
insulation pad on the
top of the appliance,
cutting around the pipe
if installing a top vent.
5. Mount the appliance
to the studs with
wood screws (2/side,
not supplied). Make
sure the framing is
leveled.
6. Proceed with the
installation of the
firebox, gas fitting,
venting and so on
as per appliance
instruction manual.
4
LOGS & ROCKS VERSIONS ONLY. Grille cannot
be used with coal fuelbed version. Install the grille
panel inside the appliance:
a. Insert the grille in the firebox by aligning one
of its side edge to the edge of the firebox as
indicated.
Grille inserted
parallel to
firebox edge
b. Raise the grille up
to cover the top
firebox ports
and hold with
one hand.
Note: The port
cover strip
supplied with
the heater is not
required.
c. Place the rear
brick wall. It
should support
the grille. If not,
keep holding it
while you place
the side brick
walls. Refer to
the fireplace
installation manual for more information on
installing the brick walls.
7. Install Touch control wall switch. The wall switch
comes with a 26-foot wire and a cover plate. The
switch is connected to the receiver in the fireplace.
The receiver is located left of the control valve
under the burner module.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires are
connected to the burner control unit as short-
circuit could result in the destruction of the
electrical components.
a. Decide where the switch is to be installed. Install
an electrical outlet box (not supplied).
b. Thread the switch wire through an access hole
in the appliance.
CAUTION
Do not run the switch wire over the top of the
firebox. Route the wire so it does not contact the
firebox.