Tightening Torque - Giant WARP 2004 Owner's Manual

5. Tightening torque.

The bolts used for the rear suspension (rear shock and pivots) are high-grade products and have been
tightened in the factory with specific torque. If it is necessary to remove or tighten the bolts, extreme care
should be taken when re-tightening them.
All bolts should be cleaned and re-set using Loctite
Threadlock (#242).
For the location and tightening torque of all bolts please refer to the illustration below (fig. 6).
Figure 6.
Location
Main pivot (BB - chain stays)
Front shock mount
Rear shock mount
TM
primer (#7649) and Loctite
Tools needed
8 mm. Allen-keys, 2x
5 mm. Allen-key,
10 mm. wrench
5 mm. Allen-key,
10 mm. wrench
Pag. -12-
TM
blue Removable
Recommended tightening torque
19~21 Nm.
9~11 Nm.
9~11 Nm.