Torque Settings; Explode Drawing - Giant FAITH Technical Manual

3. Torque settings

The bolts used to attach the rear suspension unit are very high grade products factory installed to
specific torque specification. If it becomes necessary to remove or tighten the pivot bolts extreme care
should be taken when re-tightening them.
All bolts should be cleaned and re-set using LocTite Primer (﹟243)
All bolts location and tighten torque please refer to the illustration below.
Torque settings:
1. Main pivot
2. Seatstay pivot
3. Main linkage pivot
4. Upper shock mount
5. Lower shock mount
6. Chainstay pivot

4.Explode Drawing

2
5
3
6
120 -150 Kgf/cm. ( 104 -130 in-lbs )
120 -150 Kgf/cm. ( 104 -130 in-lbs )
120 -150 Kgf/cm. ( 104 -130 in-lbs )
120 -150 Kgf/cm. ( 104 -130 in-lbs )
120 -150 Kgf/cm. ( 104 -130 in-lbs )
120 -150 Kgf/cm. ( 104 -130 in-lbs )
11
4
1