Giant WARP 2004 Owner's Manual page 9

Step 4. Measure the distance "L".
Step 5. Sit on your bicycle with your feet on the pedals in your normal riding position.
Step 6. Come off from your bike without causing too much movement in the bike. Check the rear shock and
you will see that the bumper (C) has been moved along the piston.
Measure the distance between the main body and the bumper.
This distance should be approx. 25 - 30 % of the distance "L" measured during step 4.
Adjust the compression adjustment ring (knurled compression ring E) as described above and repeat
steps 3 - 6 until you have reached this.
Figure 5.
WARNING:
Never compress the spring so far as to leave less than ½" of threads showing (between the knurled
compression ring E and the pre-load spring washer B). If the pre-load you require allows less than
½" of threads showing you may require a higher rated spring. Contact your authorised Giant dealer
for optional replacement springs.
Pag. -9-