When A Lamp Has Burned Out - Mitsubishi Fuso FK 2010 Owner's Manual

WARNING
•
Electricity is always present at one end of
the glow relay. To be safe, always discon-
nect the negative cable from the battery
before replacing the fuse.
•
Use genuine fuses of the specified amper-
ages. A fire could result if a fuse of incor-
rect amperage is used.
CAUTION
Use only a genuine fuse of the specified amper-
age.

When a lamp has burned out

Whenever replacing a lamp, be sure to place the
starter switch in the "LOCK" position and all other
switches in the "OFF" position.
WARNING
Use a lamp of the specified voltage and watt-
age shown in the following table. If a wrong
lamp is used, an excess of current flowing
through the wiring could blow a fuse or
cause the wiring to overheat and could pos-
sibly cause a fire.
CAUTION
•
Do not directly touch the glass part of a halo-
gen bulb with your fingers. Any oil and other
substances contaminating the glass surface
could shorten the bulb's service life.
•
The headlamps and turn signal lamps have
plastic lenses. Do not clean these lenses
with alcohol or thinner. Also, be careful not
to splash clutch fluid on them when adding it
to the clutch system. Contact with such a
substance could discolor or crack the
lenses. If such a substance gets on a plastic
lens, immediately wipe it off or rinse it off
with water.
•
Burnt bulbs should be replaced as soon as
possible.
13-17