Panasonic CF-73 Series Reference Manual page 148

Dealing with Problems (Advanced)
Disk Operations
Unable to read/write to the hard disk
Trouble has occurred with the disc set
in the CD/DVD drive
The multimedia pocket device status
indicator does not light
The computer does not recognize the
CD/DVD drive
Cannot play disc or read data from it
Cannot play back TV programs
recorded on a commercial DVD
recorder
Cannot play music CD or DVD-Video
automatically after setting it in the CD/
DVD drive
A blue background appears on the
screen with the MPEG image
If the CD/DVD drive vibrates
excessively or is noisy
Your drive or file may not have been properly set.
Check to see if the hard disk is full. If it is full, delete unnecessary files.
You cannot use a hard disk drive for which [Enable] has been selected in the
[Hard Disk Lock] setting of the Setup Utility by another computer.
Your hard disk content may be corrupted. Contact Panasonic Technical
Support.
You may need to clean the lens or disc.
• Cleaning the lens page 46
• Cleaning the disc page 50
Is the disc set correctly?
Remove the CD/DVD drive, and then insert it again. (
Is the disc bent, scratched, or dirty?
In the following cases, finalize the recording on the DVD recorder.
• When the program was recorded in DVD-R/RW in video mode.
• When the program was recorded in DVD-RW in VR mode.
Remove the disc and reinsert it. If the problem persists, run the applicable
software and play.
Did you open the CD/DVD drive or remove the MPEG disc while it was
operating?
Re-insert the MPEG disc and close the CD/DVD drive.
Is the disc bent or labeled?
Check to see if the disc is inserted correctly, and check that the disc is in good
condition. If the disc is good and inserted correctly, set [CD/DVD Drive Speed]
to [Low] in the Setup Utility. (
When writing to a CD using B's Recorder, you can minimize vibration while
writing by setting the writing speed at [8x] or less.
page
page 116)
148
42)