Panasonic CF-73 Series Reference Manual page 73

SD Memory Card Security Function
5
Select the SD Memory Card setting method (A).
[Leave set]
When [Leave set] is selected, leaving the SD Memory Card set serves as a
substitute for inputting the password.
(The card may be removed after the computer or Windows is started.)
[Set and eject]
When [Set and eject] is selected, setting and ejecting the SD Memory Card
serves as a substitute for inputting the password.
If you use a different method between when starting the computer and when
logging on to Windows:
In this screen, you can set the setting method for when logging on to Windows. To
set the method when starting the computer, run the Setup Utility and change the
setting of [SD Setting Method] in [Security] menu after completing the SD Card
Setup. ( page 119)
6
Make the settings according to the case to be used.
To use when starting the computer
An SD Memory Card will be registered with the computer. (Up to two cards can be
registered. To register the second card: (
A Add the check mark for [Use when starting computer] (B) and select [Next].
B Select [Restart the computer after entering settings], then select [Finish].
C
Enter the Supervisor Password.
Up to 32 alphanumeric characters (including spaces) can be used for the
password.
If the Supervisor Password has been set
Enter the Supervisor Password, then select [OK].
If the Supervisor Password has not been set
Follow the on-screen instructions to set the Supervisor Password.
Enter the Supervisor Password, then press Tab.
Reenter the Supervisor Password for confirmation, then select [OK].
Select [Yes] on the confirmation screen.
[Supervisor Password] and [Password on boot] in the [Security] menu of the
Setup Utility will be enabled.
73
page 75)