Multi-Function Board - HP EliteBook Folio 1040 G3 Maintenance And Service Manual

Multi-function board

Description
Function board
Before removing the function board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the system board (see
Remove the function board:
1. Remove the two Phillips PM2.0×3.0 screws (1) that secure the board to the computer.
2. Lift the board up to access the connector underneath (2).
3. Disconnect the cable from the bottom of the board (3), and then lift the board up and off the computer.
NOTE:
Reverse the removal procedures to install the function board.
Bottom cover on page
Battery on page
System board on page
The function board cable is available in the Cable Kit, spare part number 844396-001.
28)
29).
48).
Component replacement procedures
Spare part number
844420-001
57