Specifications - Stihl MS 460 Instruction Manual

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
Engine
STIHL single cylinder two-stroke engine
Displacement: 4.67 cu. in.
(76.5 cm
Bore: 2.05 in. (52 mm)
Stroke: 1.42 in. (36 mm)
Engine power to 6.0 hp (4.5 kW) at
ISO 7293: 9,500 rpm
Idle speed: 2,500 rpm
Maximum permissi-
ble speed with bar
and chain: 13,500 rpm
Ignition system
Electronic magneto ignition
Spark plug Bosch WSR 6 F,
(suppressed): NGK BPMR 7 A
Electrode gap: 0.02 in. (0.5 mm)
MS 460
Fuel system
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity:
Chain lubrication
Fully automatic, speed-controlled oil
pump with reciprocating piston –
additional manual oil flow control
Oil tank capacity:
Weight
dry, without bar and chain
MS 460:
MS 460 with handle
and carburetor
heating:
3
MS 460 with loop
)
handle:
Cutting attachment
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Observe the information about ANSI
standard B 175.1-2000 as well as the
definition "low-kickback saw chain" in
the section "Safety Precautions and
Working Techniques".
Rollomatic E guide bars
STIHL reduced kickback guide bars
(with green label)
Bar lengths:
27.1 fl.oz (0.8 l)
Pitch:
Groove width: 0.050 in. (1.3 mm) or
Sprocket nose: 10-tooth
Saw chains 3/8"
STIHL reduced kickback saw chain
11.0 fl.oz (0.325 l)
(with green label)
Rapid Super 3 (33 RS3) Type 3624
Pitch:
Drive link gauge:
STIHL reduced kickback saw chain
14.6 lbs. (6.6 kg)
(with green label)
Rapid Super 3 (36 RS3) Type 3626
Pitch:
15.0 lbs. (6.8 kg)
Drive link gauge:
15.2 lbs. (6.9 kg)
Chain sprockets
7-tooth for 3/8" (rim sprocket)
7-tooth for 3/8" (spur chain sprocket)
In order to comply with the kickback
performance requirements of Sec. 5.11
of ANSI standard B 175.1-2000, do not
use replacement saw chains unless they
have been designated as meeting the
ANSI Sec. 5.11 requirements on this
specific engine unit, or have been
designated as "low kickback" saw
chains in accordance with the ANSI
B 175.1-2000 standard.
English
18, 20, 25, 28 in. (45,
50, 63, 71 cm)
3/8" (9.32 mm)
0.063 in. (1.6 mm)
3/8" (9.32 mm)
0.050 in. (1.3 mm)
3/8" (9.32 mm)
0.063 in. (1.6 mm)
53