Descaling Instructions - Grimac TERRY TECH Operating Instructions Manual

c ha pt er 5 - ma int e na nc e
- Approx. every 300 coffees, clean the filter by submersing it in a water and salt
solution (regeneration). Filter life depends on the hardness of the water.
- After approx. 10-12 months replace with a new filter.
EXTERNAL HOUSING: to keep external housing clean, use a sponge or cloth soaked
with a cleaning product - neutral detergent.
Do not use solvents, abrasive powders, or scouring pads to clean.
5 . 2 - D E S C A L I N G I N S T R U C T I O N S
To descale the TERRY TECH pod coffee maker proceed as follows:
• Disconnect the water softener filter from the silicone tube.
• Disconnect the silicone tube from the water tank.
• In a container/bowl dilute a sachet of Detercaf descale in half a litre of water and place
the tube in this solution.
• Proceed as if you were dispensing coffee several times.
• Once the descale solution finishes, fill the container/bowl with clean water.
• Run a few more cycles to flush out all traces of the descale solution.
• Make sure there are no traces of this descale solution in the coffee maker.
• Reconnect the tube to the water tank.
• Reconnect the water softener filter to the tube.
Depending on use and water hardness, we recommend you descale your cof-
fee maker at regular intervals.
To regenerate the water softener filter located inside the tank, leave in a salt water solu-
tion for 8 to 10 hours.
Before replacing the water softener filter always thoroughly rinse under running water.
2 8