Chrysler 200 2016 Owner's Manual page 581

NOTE: Shifts between DRIVE and REVERSE can only be
achieved at wheel speeds of 5 mph (8 km/h) or less.
Whenever the transmission remains in NEUTRAL for
more than two seconds, you must press the brake pedal
to engage DRIVE or REVERSE.
Use the least amount of accelerator pedal pressure that
will maintain the rocking motion without spinning the
wheels or racing the engine.
NOTE: Push the ESC Off switch to place the Electronic
Stability Control (ESC) system in Partial Off mode,
before rocking the vehicle. Refer to "Electronic Brake
Control" in "Starting And Operating" for further infor-
mation. Once the vehicle has been freed, push the ESC
Off switch again to restore ESC On mode.
Racing the engine or spinning the wheels may lead to
transmission overheating and failure. Allow the en-
gine to idle with the transmission in NEUTRAL for at
least one minute after every five rocking-motion
cycles. This will minimize overheating and reduce
the risk of transmission failure during prolonged
efforts to free a stuck vehicle.
• When "rocking" a stuck vehicle by shifting be-
tween DRIVE and REVERSE, do not spin the
wheels faster than 15 mph (24 km/h), or drivetrain
damage may result.
I n f o r ma t i o n P r o v i d e d b y :
WHAT TO DO IN EMERGENCIES 579
CAUTION!
CAUTION!
(Continued)
6