Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System - Chrysler 200 2016 Owner's Manual

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the
ParkSense switch, located on the switch panel below the
Uconnect display.
ParkSense Switch
When the ParkSense switch is pushed to disable the
system, the instrument cluster will display the
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 229
"PARKSENSE OFF" message for approximately five sec-
onds. Refer to "Electronic Vehicle Information Center
(EVIC) or 7 Driver Information Display (DID)" for
further information. When the shift lever is moved to
REVERSE and the system is disabled, the EVIC/DID will
display the "PARKSENSE OFF" message for as long as
the vehicle is in REVERSE.
The ParkSense switch LED will be ON when ParkSense is
disabled or requires service. The ParkSense switch LED
will be OFF when the system is enabled. If the ParkSense
switch is pushed, and requires service, the ParkSense
switch LED will blink momentarily, and then the LED
will be ON.

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle, and it will display the "PARKSENSE
I n f o r ma t i o n P r o v i d e d b y :
3