Chrysler 200 2016 Owner's Manual page 32

Hide thumbs Also See for 200 2016:

Table of Contents

30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE

To Exit Remote Start Mode Without Driving The

Push and release the REMOTE START button one time or

allow the engine to run for the entire 15-minute cycle.

NOTE: To avoid unintentional shutdowns, the system

will disable the one time push of the REMOTE START

button for two seconds after receiving a valid Remote

Start request.

To Exit Remote Start Mode And Drive The Vehicle

Before the end of 15-minute cycle, push and release the

UNLOCK button on the RKE transmitter to unlock the

doors and disarm the Vehicle Security Alarm (if

equipped). Then, prior to the end of the 15-minute cycle,

push and release the START/STOP button (vehicles

equipped with Keyless Enter-N-Go).

NOTE: The message Remote Start Active Push Start

Button (vehicles equipped with Keyless Enter-N-Go)

will display in the instrument cluster until you push the

START button.

General Information

The following regulatory statement applies to all radio

frequency (RF) devices equipped in this vehicle:

This device complies with Part 15 of the FCC Rules and

with Industry Canada licence-exempt RSS standard(s).

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received,

including interference that may cause undesired op-

NOTE: Changes or modifications not expressly approved

by the party responsible for compliance could void the

user's authority to operate the equipment.

I n f o r ma t i o n P r o v i d e d b y :

Chapters

Table of Contents