Adjusting The Steering Angle; Basic Setting Of The Chassis According To The Rider Weight; Setting The Fork Compression - SHERCO 250 SEF/R Owner's Manual

AdJUSTinG THe STeeRinG AnGLe

BASiC SeTTinG OF THe CHASSiS ACCORdinG TO THe RideR
WeiGHT
Standard weight of the-
rider (with equipment)

SeTTinG THe FORK COMPReSSiOn

The steering angle can be changed using the set
screws located on the bottom of the steering
column.
Loosen the nut
until you have the steering angle desired.
1
Tighten the nut and do the same operation on
the other side.
2
Steering angle
lock nut
If the weight of the rider is above or below the
75 à 85kg
standard, compensate by changing the stiffness
of the springs (forks and shock).
Screws
when it is compressed. Turning in the screw-
1
clockwise increases the hydraulic force (and
vice versa).
Remove the caps
the fork.
2
Turn screw
back the number of clicks required.
Adjusting the compression
Sachs Series Gold Ø48mm
Adjustable compression
WP Suspension USD
Ø48mm
Replace the cap
and tighten the screw
1
M8
determine the behavior of the fork
2
located at the lower end
1
clockwise to the stop and go
2
.
1
2
20Nm
12 clics
20
Comfort
clicks
13
Standard
clicks
8
Sport
clicks
91